SYNTHESIS®FOURS4VC, S4HC & S4AiFLUSH-MOUNTLOUDSPEAKERSOWNER’S AND INSTALLER’SMANUALS4VC/HC/Ai OM 8/19/08 3:26 PM Page 1
S4Ai DUAL-DRIVE MODEAs the S4Ai has the capability of producing both side and rear fields from a single location in Bipole mode whiledual-driven for c
than 1/4". The grille pins fit directly into the speaker cabinet via receiver bushings with 15 ft/lb of tension per pin.Use the marked speaker-de
12REQUIREMENTS FOR MOUNTINGOPTION 2 – RETROFIT/PREEXISTINGCONSTRUCTION: Use the S4RFB bracket.Mount the S4RFB to the wall surface and secureit to stud
13To connect the Synthesis Four loudspeakers to the power amplifiers or receiver, use two-conductor insulated speakerwire. We recommend #14 AWG wire a
14SYMPTOM PROBABLE CAUSE SOLUTIONNo sound coming • Amplifier is not turned on • Turn on amplifier.from speaker• Amplifier gain is low • Make sure th
SPECIFICATIONS15MODEL # S4VC S4HC S4AiDescription 3-Way 8" (200mm) vertical 3-Way dual 6-1/2" (165mm) Configurable-array flush-flush-mount
Harman Consumer Group, Inc.250 Crossways Park DriveWoodbury, NY 117978500 Balboa BoulevardNorthridge, CA 91329516.594.0300Technical Support: 516.682.3
INTRODUCTION ...
Thank you for purchasing JBL Synthesis®Four flush-mount home theater loudspeakers. These products represent thesynthesis of everything that JBL, Inc.,
or or4One S4HC horizontal channel flush-mount loudspeakerOne S4VC vertical channel flush-mou
Positioning your loudspeakers properly is critical in order to achieve the sonic performance of a home theater. Please read the following section for
NOTE:It is extremely important to place the tweeter/mid-bass arrays for each of the center, left and right speakers at the same height. The EOS wavegu
7.1-CHANNEL SYSTEMSIn a 7.1-channel system, two speakers are added for rear fill, in addition to the sur-round speakers in a 5.1-channel system. The t
WHICH DIFFUSE MODE IS THE RIGHT ONE FOR THE JOB?BIPOLE MODE IS TYPICALLY USED WHEN: RECOMMENDED (FACTORY-DEFAULT) MODE• The speaker is located relativ
In a 7.1-channel system, where twoadditional S4Ai speakers may bemounted in the rear wall, the positivephase arrays should both fire towardthe center
Kommentare zu diesen Handbüchern